User's Manual
Table Of Contents
Indoor Mobility Point™ Quick Start Guide
37
Trapeze Networks
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
4. Place the MP in the desired location on the table.
5. If the MP requires an external antenna, install and connect the antenna.
Connecting an MP to an External Antenna
Each radio in an Indoor MP can use an optional Trapeze external antenna. To mount the antenna, see
the instructions that come with the antenna.
To connect a mounted external antenna to an MP:
1. Attach the exterior antenna cable that is shipped with the antenna to the MP external antenna
connector.
Both connectors are labeled to indicate the radio type. The MP has RP-SMA connectors
for attachment to the 802.11b/g antenna and to the 802.11a antenna.
2. Attach the other end of the antenna cable to the antenna.
Installing an Indoor MP-522E
The MP-522E installation steps for ceiling or wall mount are the same as the MP-422/432/522 except
that you must install and orient the four antennas on the MP before supplying power to the unit. The
MP-522E has no internal antennas and requires antennas for all types of operation.Once the MP is
installed on either the wall or ceiling with antennas attached you can switch between Radio 1 and 2
using the CLI command “set ap # radio x mode disable.”
!
Caution
The external connectors on the MP are labeled: 11B/G and 11A. Each connector is a
standard RP-SMA connector. Make sure you attach the antenna to the correct
connector.
Note:
If the MP is installed in a Trapeze Networks outdoor MP enclosure, attach the
antenna cable to the lightning surge arrestor (if installed) or the RP-SMA bulkhead
connector on the enclosure.
W arning!
Always install the four MP-522E antennas before supplying power to the MP. Failure to
do so can cause damage to the unit.
The tested/certified antennas are equipped with Reverse-SMA or N-type jacks.
This device and its antenna(s) must not be co-located or operated in conjunction with
any other antenna or transmitter.
W arning!
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in
indoor environment only.