User's Manual

Indoor Mobility Point™ Quick Start Guide
31
Trapeze Networks
d. If you plan to route the Cat 5 cable through a hole in the wall or ceiling, mark the location of the
center screw hole only. You cannot use the screw hole by the port connector opening if you cut a
hole for the opening.
e. Remove the template.
2. Install the drywall anchor(s):
a. Hammer a drywall anchor into each hole, up to the beginning of the threads on the anchor.
b. Screw each anchor the rest of the way into the hole using a #2 Phillips-head screwdriver.
c. Remove the screw from each anchor and save the screw(s) for step 6.
3. Unlock the universal mounting bracket from the MP by inserting the lock/unlock tool into the
Unlock hole on the MP as shown below.
Figure 1–24. Step 3—Unlocking the Bracket
Note:
Do not mark the four holes on the edges of the bracket. (These are the holes indicated
by the dashed lines in Figure 1–26.) The MP fits into these holes. They are not screw
holes.
!
Caution
Use the lock/unlock tool to unlock the MP. Do not use a screwdriver because it may
cause damage to the MP lock mechanism or electronic components. Do not use
excessive force when inserting a tool into the Unlock or Lock hole.