User's Manual

Indoor Mobility Point™ Quick Start Guide
30
Trapeze Networks
8. Lock the MP onto the bracket by inserting a small-pointed instrument or a paperclip into the
Lock hole on the MP as shown in Figure 1–23.
Figure 1–23. Step 7—Locking the Bracket
9. To ensure that the MP is fully locked onto the bracket, gently pull down on the MP and attempt to
rotate it from side to side.
If the MP comes off the bracket, relock the device onto the bracket as described in step 8.
10. If the MP requires an external antenna, install and connect the antenna.
11. If the other ends of the Cat 5 cable(s) are not already connected and the link activated, go to ”.
Solid Wall or Ceiling Installation
1. Prepare holes in the wall or ceiling for the universal mounting bracket, using the following steps:
a. Place the paper mounting template over the location to install the MP.
b. Mark the screw hole location(s).
c. If you plan to route the Cat 5 cable externally along the wall or ceiling, mark the locations of
both the center screw hole and the screw hole by the port connector opening.
W arning!
To prevent possible damage to the MP, make sure the device is fully locked onto the
bracket before releasing it.
Note:
The solid surface mounting option requires Cat 5 cable that does not have strain relief,
unless you plan to route the cable through a hole in the wall or ceiling. The other
options can use Cat 5 cable with or without strain relief.
Lock