User's Manual

Indoor Mobility Point™ Quick Start Guide
29
Trapeze Networks
Figure 1–22. Step 3—Placing the Bracket on the Junction Box
4. Pull the Cat 5 cable(s) about 15 centimeters (about 6 inches) out of the junction box and through
the port connector opening to create enough slack to insert the cable(s) into the port connectors.
5. Insert the Cat 5 cable(s) into the connector(s):
❑ For a single connection, use the connector for port 1.
❑ For redundancy, insert one cable into each connector.
6. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a person
pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
7. Lift the MP into place on the universal mounting bracket.
Make sure the cable feeds properly into the junction box as you lift the device, and does not
become trapped between the MP and the bracket.
Junction box
Port connector
opening