User's Manual

Indoor Mobility Point™ Quick Start Guide
23
Trapeze Networks
12. Lock the MP onto the bracket by inserting a small-pointed instrument or a paperclip into the
Lock hole on the MP as shown in Figure 1–11 below.
Figure 1–11. Step 12—Locking the Bracket
13. To ensure that the MP is fully locked onto the bracket, gently pull down on the MP and attempt to
rotate it from side to side.
14. If the MP comes off the bracket, relock the device onto the bracket as described in step 12 on
page 22.
15. If the MP requires an external antenna, install and connect the antenna.
Suspended Ceiling Installation—Drop Ceiling Tiles
(For required mounting hardware and tools, see Table 1– 2 on page 12.)
1. Select an installation location that is centered over a T-bar in the ceiling.
2. Cut a hole as follows in the ceiling tile for the Cat 5 cable(s):
a. Place the mounting template over the area where you plan to install the MP.
b. Use the box cutter to cut along the line marking the opening for the port connectors.
c. Remove the mounting template and the material you cut from the ceiling panel.
3. Install the T-bar clamp that fits the T-bar:
a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.
b. Slide the two halves of the clamp toward each other until the tabs are inserted completely into
the holes and the clamp fits snugly on the T-bar.
W arning!
To prevent possible damage to the MP, make sure the device is fully locked onto the
bracket before releasing it.
Lock