User's Manual

Table Of Contents

Indoor Mobility Point™ Quick Start Guide

Trapeze Networks

8. Pull the Cat 5 cable(s) about 15 centimeters (about 6 inches) out of the hole in the ceiling tile and

through the port connector opening to create enough slack to insert the cable(s).

9. Insert the Cat 5 cable(s) into the connector(s):

❑ For a single connection, use the connector for port 1.

❑ For redundancy, insert one cable into each connector.

Note:

MP-522-Specific Optional Earthquake Safety Step

At this point, once you have the T-bar installed and the universal mounting bracket

snapped into place, you have the option of securing the bracket for earthquake safety

using the two supplied M3 pan head threaded screws.

Note that the T-bars and the universal mounting bracket in the MP-522 Installation

Kit have two additional screw holes as shown below.

When the universal mounting bracket is snapped into place, the holes will align.

Screw the two M3 pan head threaded screws into the holes. The screws will hold the

T-bar and universal mounting bracket together in the event of an earthquake. The

MP-522 is then locked securely into place on the secured universal mounting bracket.

M3 pan head screw