User's Manual

Indoor Mobility Point™ Quick Start Guide
17
Trapeze Networks
11. Lock the MP onto the bracket by inserting the lock/unlock tool into the Lock hole on the MP and
push until you feel the internal bracket slide across.
12. To ensure that the MP is fully locked onto the bracket, gently pull down on the MP and attempt to
rotate it from side to side.
13. If the MP comes off the bracket, relock the device onto the bracket.
14. If the MP requires an external antenna, install and connect the antenna.
MP-82 Wall Mount Installation
Use the included universal mounting bracket to wall mount the MP.
1. Screw the universal mounting bracket directly to a wall.
❑ If mounting to drywall, use two screws and two wall anchors in the provided holes on the
bracket that are circled in red below.
2. Connect the Ethernet cable (for power and network connection) to the port on the back of the
MP-82.
W arning!
To prevent possible damage to the MP, make sure the device is fully locked onto the
bracket before releasing it.