User's Manual

Indoor Mobility Point™ Quick Start Guide
15
Trapeze Networks
b. Properly align the bracket for mounting by placing the bracket so the port connector opening is
to the left of the hole you cut for the cables.
c. Rotate the universal mounting bracket clockwise until the flanges snap into place on the T-bar
or clamp as shown in the figure below.
Figure 1–4. Step 7—Bottom View
6. Pull the Cat 5 cable(s) about 15 centimeters (about 6 inches) out of the hole in the ceiling tile and
through the port connector opening to create enough slack to insert the cable(s).
7. Insert the Cat 5 cable(s) into the connector(s):
❑ For a single connection, use the connector for port 1.
❑ For redundancy, insert one cable into each connector.
8. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a person
pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
T- b a r
Universal mounting bracketPort connector
opening