Quick Start Guide

Indoor Mobility Point™ Quick Start Guide
31
Trapeze Networks
Figure 1–23. Step 7—Locking the Bracket
9. To ensure that the MP is fully locked onto the bracket, gently pull down on the MP and attempt to
rotate it from side to side.
If the MP comes off the bracket, relock the device onto the bracket as described in step 8.
10. If the MP requires an external antenna, install and connect the antenna.
Solid Wall or Ceiling Installation
1. Prepare holes in the wall or ceiling for the universal mounting bracket, using the following steps:
a. Place the paper mounting template over the location to install the MP.
b. Mark the screw hole location(s).
c. If you plan to route the Cat 5 cable externally along the wall or ceiling, mark the locations of
both the center screw hole and the screw hole by the port connector opening.
d. If you plan to route the Cat 5 cable through a hole in the wall or ceiling, mark the location of the
center screw hole only. You cannot use the screw hole by the port connector opening if you cut a
hole for the opening.
e. Remove the template.
Note:
The solid surface mounting option requires Cat 5 cable that does not have strain relief,
unless you plan to route the cable through a hole in the wall or ceiling. The other
options can use Cat 5 cable with or without strain relief.
Note:
Do not mark the four holes on the edges of the bracket. (These are the holes indicated
by the dashed lines in Figure 1–26.) The MP fits into these holes. They are not screw
holes.
Lock