Quick Start Guide

Indoor Mobility Point™ Quick Start Guide
22
Trapeze Networks
8. Pull the Cat 5 cable about 15 centimeters (about 6 inches) out of the hole in the ceiling tile and
through the port connector opening to create enough slack to insert the cable.
9. Insert the Cat 5 cable into the connector.
10. Install the Kensington lock, if you plan to use one.
Note:
MP-522-Specific Optional Earthquake Safety Step
At this point, once you have the T-bar installed and the universal mounting bracket
snapped into place, you have the option of securing the bracket for earthquake safety
using the two supplied M3 pan head threaded screws.
Note that the T-bars and the universal mounting bracket in the MP-522 Installation
Kit have two additional screw holes as shown below.
When the universal mounting bracket is snapped into place, the holes will align.
Screw the two M3 pan head threaded screws into the holes. The screws will hold the
T-bar and universal mounting bracket together in the event of an earthquake. The
MP-522 is then locked securely into place on the secured universal mounting bracket.
M3 pan head screw
M3 pan head screw