Quick Start Guide

Table Of Contents

Indoor Mobility Point™ Quick Start Guide

Trapeze Networks

14. If the MP requires an external antenna, install and connect the antenna.

MP-82 Wall Mount Installation

Use the included universal mounting bracket to wall mount the MP.

1. Screw the universal mounting bracket directly to a wall.

❑ If mounting to drywall, use two screws and two wall anchors in the provided holes on the

bracket that are circled in red below.

2. Connect the Ethernet cable (for power and network connection) to the port on the back of the

MP-82.

3. Unlock the MP by inserting the lock/unlock tool into the Unlock hole and push until you feel the

internal bracket slide across.

4. Mount the MP-82 onto the mounting bracket.

5. Lock the MP onto the bracket by inserting the lock/unlock tool into the Lock hole on the MP and

push until you feel the internal bracket slide across

Installing an Indoor MP-422/432/522

Suspended Ceiling Installation — Flush Ceiling Tiles for the MP-422/432/522

1. Select an installation location centered over a T-bar in the ceiling.

2. Cut a hole as follows in the ceiling tile for the Cat 5 cable:

a. Place the mounting template over the area where you plan to install the MP.

b. Use the box cutter to cut along the line marking the opening for the port connectors.

c. Remove the mounting template and the material you cut from the ceiling panel.

3. Determine whether to install a T-bar clamp onto the ceiling T-bar:

❑ If the T-bar width is 14.2 millimeter (9/16 inches), you need to install the 14.2-millimeter (9/

16 inches) T-bar clamp. Go to step 4.

❑ If the T-bar width is 23.9 millimeter (15/16 inches), the universal mounting bracket fits

directly onto the T-bar. Go to step 5.

4. Install the 14.2-millimeter (9/16-inch) T-bar clamp onto the ceiling T-bar as shown in Figure 1–5.

a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.

b. Slide the two halves of the clamp toward each other until the tabs are inserted completely into

the holes and the clamp fits snugly on the T-bar.