User's Manual

I nst a lling a nd Conne ct ing a n I ndoor M P
Installing an Indoor MP
Installing and Connecting an Indoor MP 2 – 17
(If you routed the Cat 5 cable through a hole in the wall or ceiling, insert the screw into the
center screw hole only.)
Figure 2–24. Steps 5 and 6—Bracket Placement on Solid Wall or Ceiling
7. Insert the Cat 5 cable(s) into the connector(s):
❑ For a single connection, use the connector for port 1.
❑ For redundancy, insert one cable into each connector.
8. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a
person pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
9. As shown in
Figure 2–25, place the MP on the bracket, making sure to remove any slack that
occurs in the cable between the bracket and the MP.
Note:
Do not insert screws in the four holes on the edges of the bracket. (These are the holes
indicated by the dashed lines in Figure 2–24.) The MP fits into these holes. They are
not screw holes.