User's Manual
I nst a lling a nd Conne ct ing a n I ndoor M P
Installing an Indoor MP
Installing and Connecting an Indoor MP 2 – 13
Junction Box Installation
(For required mounting hardware and tools, see
Table2– 1 on page2-4.)
1. Unlock the universal mounting bracket from the MP by inserting a small-pointed instrument
or a paperclip into the Unlock hole on the MP as shown in
Figure 2–18.
Figure 2–18. Step 1—Unlocking the Bracket
2. Remove the bracket as shown in
Figure 2–19.
Figure 2–19. Step 2—Removing the Bracket
3. Attach the universal mounting bracket to the junction box as shown in
Figure 2–20:
a. Place the universal mounting bracket against the junction box so that the two screw holes
face the junction box and align over the screw holes in the box.
b. Insert the #6-32 x 1-inch machine screws in the universal mounting bracket screw holes,
and use a #2 Phillips-head screwdriver to tighten them.
!
Caution
Use a small-pointed instrument or a paperclip to unlock the MP. Do not use a
screwdriver because it may cause damage to the MP lock mechanism or electronic
components. Do not use excessive force when inserting a tool into the Unlock or Lock
hole.