User's Manual

Installing and Connecting an Indoor MP
Installing an Indoor MP
Indoor Mobility Point Installation Guide
2 – 10
4. Unlock the universal mounting bracket from the MP by inserting a small-pointed instrument
or a paperclip into the Unlock hole on the MP as shown in
Figure 2–12.
Figure 2–12. Step 4—Unlocking the Bracket
5. Remove the bracket as shown in
Figure 2–13.
Figure 2–13. Step 5—Removing the Bracket
6. Install the universal mounting bracket as follows onto the T-bar clamp:
a. As shown in
Figure 2–14, place the universal mounting bracket against the T-bar clamp so
that the two screw holes face downward and the two T-bar flanges face upward and are
adjacent to the T-bar edges.
b. Properly align the bracket for mounting by placing the bracket so that the port connector
opening is to the left of the hole you cut for the cables.
c. Rotate the universal mounting bracket clockwise until the flanges snap into place on the
T-bar clamp as shown in
Figure 2–15.
!
Caution
Use a small-pointed instrument or a paperclip to unlock the MP. Do not use a
screwdriver because it may cause damage to the MP lock mechanism or electronic
components. Do not use excessive force when inserting a tool into the Unlock or Lock
hole.