User's Manual

Installing and Connecting an Indoor MP 2 – 1
2
2
Installing and Connecting an Indoor MP
Unpacking an MP
The shipping carton for an MP contains the following items:
1. One MP
2. Mounting kit including:
One universal mounting bracket (attached to the MP)
One paper mounting template (used for marking cutting areas and screw holes)
One two-piece 9/16-inch (14.2-mm) T-bar clamp
One two-piece 5/8-inch (15.9-mm) T-bar clamp
One two-piece 15/16-inch (23.9-mm) T-bar clamp
Two #6 sheet metal screws and two drywall anchors
Three adhesive rubber feet
3. One documentation pack that includes quick mounting instructions and a registration card
(not shown)
Figure 2–1 shows the contents of the shipping carton for the Indoor MPs.
Figure 2–1. Shipping Carton Contents
Note:
Before installing an MP, you might need to generate a network plan and an MP work
order with RingMaster. (See “RingMaster Network Plan and Work Orders” on
page2-2.)
T- b ar clamps
Mounting template
Rubber feet
Universal
mounting bracket
Mounting hardware
Mobility point