User's Manual

MP-622 Technical Specifications
Federal Communication Commission Interference Statement
MP-622 Installation Guide
4 – 2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Maximum Clients 64 for the radio interface set to access point mode
Modulation Types 802.11a: BPSK, QPSK, 16-QAM, 64-QAM
802.11g: CCK, BPSK, QPSK, OFDM
802.11b: CCK, BPSK, QPSK
Network Configuration Access Point Mode:
Infrastructure
Bridge Mode:
Point-to-point and point-to-multipoint
Operating Frequency 802.11a:
5.15 GHz to 5.825 GHz based on country regulations
802.11b/g:
2.4 GHz to 2.4835 GHz based on country regulations
Power Injector Input: 90-240 VAC; 50/60 Hz
Output: 48 Vdc/0.63A, 12Vdc/1A
Physical Size 7.68 x 7.48 x 2.91 in (19.5 x 19 x 7.4 cm)
Weight 3.4 lbs (1.54 kg)
Temperature Operating: -22 to 131 °F (-30 to 55 °C)
Storage: -40 to 176 °F (-40 to 80 °C)
Humidity 5% to 95% (non-condensing)
EMC Compliance (Class B) FCC Class B (US)
RTTED 1999/5/EC
DGT (Taiwan)
Radio Signal Certification
FCC Part 15.247 (2.4 GHz)
IC RSS-210
EN 300.328, EN 302.893
EN 300 826, EN 301.489-1, EN 301.489-17
ETSI 300.328; ETS 300 826 (802.11b)
Safety UL/cUL60950-1, IEC60950-1 (CB) and IEC60529 IP68
(NEMA250 6P)
Standards IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX,
IEEE 802.11a, b, g
Table 4– 1. MP-622 Mechanical and Compliance Specifications (continued)
Specification Description