User's Manual

Installing and Connecting an MP-622
Installing an MP-622
Installing and Connecting an MP-622 3 – 13
Figure 3–7. 10/100 Cat 5 Cable Installation
1. Insert a Cat 5 cable with a standard RJ-45 connector as shown in Figure 3–7. For connection to
an MP, use a straight-through cable.
2. When the link is activated, observe the MP LED for the port on the MX:
MX Port LEDs for MP
Connections
Meaning
Solid green For an MP access point active link, all the following are true:
MP has booted.
MP has received a valid configuration from the MX switch.
Management link with an MP is operational.
At least one radio is enabled or is in sentry mode.
For an MP secondary link, the link is present.
Alternating green and
amber
MP is booting with an image received from the MX switch. After the access
point boots and receives its configuration, this LED appearance persists
until a radio is enabled or is placed in sentry mode.
Solid amber PoE is on.
Blinking amber MP is unresponsive or there is a PoE problem.
Unlit PoE is off.
Note:
The MX 10/100 Ethernet ports are configured as wired network ports by default. You
must change the port type for an MX port directly connected to an MP to activate the
link. (See the Mobility Exchange Installation and Basic Configuration Guide.)