User's Manual

Installing and Connecting an MP-622
Installing an MP-622
Installing and Connecting an MP-622 3 – 11
1. Connect the Ethernet cable from the wireless bridge to the RJ-45 port labeled “Output” on the
power injector.
2. Connect a straight-through unshielded twisted-pair (UTP) cable from a local LAN switch to the
RJ-45 port labeled “Input” on the power injector. Use Category 5e or better UTP cable for 10/
100BASE-TX connections.
3. Insert the power cable plug directly into the standard AC receptacle on the power injector.
4. Plug the other end of the power cable into a grounded, 3-pin socket, AC power source.
Checking the LED Indicators
The 11a and 11b/g LEDs on the MP-622 operate in two display modes, which are configurable
through the software. The default AP mode indicates data traffic rates. The RSSI mode indicates
the received signal power and is used when aligning antennas in a bridge link.
W arning!
You must align the UTP cable with the pins in the RJ-45 “Input” port. If you force the
cable into the port, you will damage the unit and can bend the power injector pins.
The picture below shows an example of a port with two bent bottom pins.
Note:
For International use, you may need to change the AC line cord. You must use a line
cord set that has been approved for the receptacle type in your country.