User's Manual

Installing and Connecting an MP-622
Installing an MP-622
MP-622 Installation Guide
3 – 10
Figure 3–6. Attaching an Ethernet Cable to the MP-622
Connecting the Outdoor Power Supply
For instructions on connecting the outdoor power supply to the MP-622, refer to Installing an
Outdoor Power Supply (Model XPS-620x-OUT). Be sure to contact a fully qualified electrician to
perform the installation.
Connecting the Power Injector
To connect the wireless bridge to a power source:
Note:
The Ethernet port on the wireless bridge does not support Power over Ethernet
(PoE) based on the IEEE 802.3af standard. Do not try to power the unit by
connecting it directly to a network switch that provides IEEE 802.3af PoE. Always
connect the unit to the included power injector module.