User's Manual

Installing and Connecting an MP-622
Installing an MP-622
Installing and Connecting an MP-622 3 – 9
Figure 3–5. Connecting External Antennas to the MP-622
Connecting Cables to the Unit
1. Attach the Ethernet cable to the Ethernet port on the MP-622.
2. For extra protection against rain or moisture, apply weatherproofing tape (not included)
around the Ethernet connector.
3. Be sure to ground the unit with an appropriate grounding wire (not included) by attaching it to
the grounding screw on the unit.
4. Be sure to install a lightning arrestor on the Ethernet cable between the bridge and power
injector. The lightning arrestor should be placed outdoors, immediately before the Ethernet
cable enters the building.
W arning!
Be sure that grounding is available and that it meets local and national electrical
codes. For additional lightning protection, use lightning rods, lightning arrestors, or
surge suppressors.
RF Coaxial Cable
2.4 GHz External
Omnidirectional
Antenna
2.4 GHz N-type Connector
5 GHz
N-type Connector
5 GHz External
High-gain Panel
Antenna