User's Manual

Installing and Connecting an MP-622
Installing an MP-622
MP-622 Installation Guide
3 – 8
b. Attach the ground-wire terminal lug, lock washer, and hex nut to the lightning arrestor, in
the order shown in Figure 3–4 below.
Figure 3–4. Attaching the Ground-Wire Terminal Lug, Lock Washer, and Hex Nut to the Lightning
Arrestor
c. Connect one end of the short RF coaxial cable to the MP-622 N-type connector, and connect
the other end to the lightning arrestor.
d. Connect one end of the 3m RF coaxial cable to the lightning arrestor, and connect the other
end to the outdoor antenna. Continue with step 4.
3. Connect the antenna to the MP-622 N-type connector using the RF coaxial cable provided in
the antenna package.
4. Apply weatherproofing tape to the antenna connectors to help prevent water entering the
connectors.
Note:
To meet regulatory requirements, you must ensure that the external antenna
specified with the set ap radio antennatype command exactly matches the external
antenna attached to the MP-622 external antenna port.
To External Antenna
To MP-622
6-gauge
Grounding Cable
Grounding Nut
Locking Washer
Hex Nut
Lightning Protector