User's Manual

Installing and Connecting an MP-622
Installing an MP-622
MP-622 Installation Guide
3 – 6
Mounting on Larger Diameter Poles
There is also a method for attaching the pole-mounting bracket to a pole that is 2 to 5 inches in
diameter using an adjustable steel band clamp (not included in the kit). A steel band clamp up to
0.5 inch (1.27 cm) wide can be threaded through the main part of the bracket to secure it to a
larger diameter pole without using the U-shaped part of the bracket. This method is illustrated in
the following figure.
Figure 3–2. Attaching the Bracket Using a Steel Band Clamp
Using the Wall-Mounting Bracket
Perform the following steps to mount the unit to a wall using the wall-mounting bracket.
1. Always attach the bracket to a wall with the flat side flush against the wall (see following
figure).
Figure 3–3. Wall-Mounting Bracket
2. Position the bracket in the intended location and mark the position of the four mounting screw
holes.
Note:
The wall-mounting bracket does not allow the integrated antenna of the wireless
bridge to be aligned. It is intended for use with the unit using an external antenna.