User's Manual

MP-622 Installation Guide
1 - 6
Water Tight Test Point
Wall- and Pole-Mounting Bracket Kits
The MP-622 includes bracket kits that can be used to mount the unit to a wall, pole, radio mast, or
part of a tower structure.
Lightning Protector for Outdoor Antenna
If you are using the MP-622 with an outdoor antenna, Trapeze Networks strongly recommends
installing an external lightning protector for the antenna. An external lightning protector may be
obtained from Trapeze Networks.
System Configuration
At each location where an MP-622 unit is installed, it must be connected to the local network
using the power injector module. The following figure illustrates the system component
connections.
Figure 1–4. System Component Connections
Features and Benefits
The MP-622 provides the following features and benefits:
The MP-622 supports access point services for the 5 GHz and 2.4 GHz radios using various
external antenna options
MP-622 units support 5 GHz point-to-multipoint links using various external antenna options
Maximum data rate up to 54 Mbps on the 802.11a (5 GHz) radio
Outdoor weatherproof design
IEEE 802.11a and 802.11b/g compliant
Local network connection via 10/100 Mbps Ethernet port
Powered through its Ethernet cable connection to the power injector module
Includes wall- and pole-mount brackets
W arning!
Do not remove or loosen this screw. If you do, you can damage the unit.
LAN Switch
Indoor Out
door
AC Power
Power
Injector
MP-622 Unit
Ground Wire
Ethernet Cable Ethernet Cable
External Antenna
RF Coaxial Cable
Lightning
Protector