User Manual
Table Of Contents
- Customer Service
- Introducing the Trapeze Networks Mobility System
- MP-620 Overview
- Installing and Connecting an MP-620 Access Point
- MP-620 Technical Specifications
- Cables and Pinouts
- Index
Cables and Pinouts
43
B
Cables and Pinouts
This appendix describes the wiring and pin assignments for the cables and
connectors that can be used with the MP-620.
Twisted-Pair Cable Assignments
For 10/100BASE-TX connections, a twisted-pair cable must have two pairs of
wires. Each wire pair is identified by two different colors. For example, one wire
might be green and the other, green with white stripes. Also, an RJ-45 connector
must be attached to both ends of the cable.
The following figure illustrates how the pins on the RJ-45 connector are
numbered. Be sure to hold the connectors in the same orientation when attaching
the wires to the pins.
Caution! Each wire pair must be attached to the RJ-45 connectors in a
specific orientation.
Caution! DO NOT plug a phone jack connector into a power injector RJ-45
port. Use only twisted-pair cables with RJ-45 connectors that conform with FCC
standards.