User Manual

Federal Communication Commission Interference Statement
Appendix A
MP-620 Technical Specifications
31
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
Humidity 5% to 95% (non-condensing)
EMC Compliance (Class B) FCC Class B (US)
RTTED 1999/5/EC
DGT (Taiwan)
Radio Signal Certification FCC Part 15 15.407(b) (5 GHz)
FCC Part 15.247 (2.4 GHz)
IC RSS-210
EN 300.328, EN 302.893
EN 300 826, EN 301.489-1, EN 301.489-17
ETSI 300.328; ETS 300 826 (802.11b)
Safety UL/cUL60950-1, IEC60950-1 (CB), IP68 (NEMA-250 6P)
Standards IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX,
IEEE 802.11a, b, g
Table 2. MP-620 Mechanical and Compliance Specifications
Specification Description