User Manual

Installing an MP-620
Chapter 3
Installing and Connecting an MP-620 Access Point
21
Using the Wall-Mounting Bracket
Perform the following steps to mount the unit to a wall using the wall-mounting
bracket:
1 Always attach the bracket to a wall with the open end of the mounting
grooves facing up (see following figure).
Figure 7. Wall-Mounting Bracket
2 Position the bracket in the intended location and mark the position of the three
mounting screw holes.
3 Drill three holes in the wall that match the screws and wall plugs included in
the bracket kit, then secure the bracket to the wall.
4 Use the included nuts to tightly secure the MP-620 to the bracket.
Connecting External Antennas
When deploying an MP-620 access point, you need to mount external antennas
and connect them to the unit. Typically, access point operation requires a 2.4 GHz
antenna.
Perform these steps:
1 Mount the external antenna to the same supporting structure as the MP-620,
within 3 m (10 ft) distance, using the bracket supplied in the antenna package.
2 If you are installing the optional lightning protector for an outdoor antenna,
perform the following steps. Otherwise, skip to step 3.
Mounting Grooves