User Manual
Table Of Contents
- Customer Service
- Introducing the Trapeze Networks Mobility System
- MP-620 Overview
- Installing and Connecting an MP-620 Access Point
- MP-620 Technical Specifications
- Cables and Pinouts
- Index
System Configuration
Chapter 2
Trapeze MP-620 Installation Guide
12
Receive Signal Strength Indicator (RSSI) BNC
Connector
This connector is unused at this time.
Grounding Point
Even though the MP-620 includes its own built-in lightning protection, it is
important that the unit is properly connected to ground. A grounding screw is
provided for attaching a ground wire to the unit.
Wall- and Pole-Mounting Bracket Kits
The MP-620 includes bracket kits that can be used to mount the unit to a wall,
pole, radio mast, or part of a tower structure.
Lightning Protector for Oudoor Antenna
If you are using the MP-620 with an outdoor antenna, Trapeze Networks
recommends installing an external lightning protector for the antenna.
System Configuration
At each location where an MP-620 unit is installed, it must be connected to the
local network using the power injector module. The following figure illustrates
the system component connections.