User Manual

Table Of Contents

Installing a Trapeze Networks™ Model MP-620 Mobility Point™ Access Point

Mount the MP-620

You can mount the MP-620 on a pole or on a wall using the supplied hardware.

Using the Pole-Mounting Bracket

Perform the following steps to mount the unit to a 1.5 to 2 inch diameter steel pole or tube using the

mounting bracket:

1 Always attach the bracket to a pole with the open end of the mounting grooves facing up.

2 Place the U-shaped part of the bracket around the pole and tighten the securing nut just enough to hold

the bracket to the pole. (The bracket may need to be rotated around the pole during the alignment

process.)

Figure 1. Attaching the Bracket to the Pole

3 Use the included nuts to tightly secure the MP-620 to the bracket.

Mounting on Larger Diameter Poles

In addition, there is a method for attaching the pole-mounting bracket to a pole that is 2 to 5 inches in

diameter using an adjustable steel band clamp (not included in the kit). A steel band clamp up to 0.5 inch

(1.27 cm) wide can be threaded through the main part of the bracket to secure it to a larger diameter pole

without using the U-shaped part of the bracket. This method is illustrated in the following figure.

Attach bracket to

pole with mounting

grooves facing up