User's Manual

Indoor Mobility Point™ Quick Start Guide
30
Trapeze Networks
Connecting an MP to an External Antenna
Each radio in an MP-422 or MP-372 can use an optional Trapeze external antenna. To mount the
antenna, see the instructions that come with the antenna.
To connect a mounted external antenna to an MP-422 or MP-372:
1. Attach the exterior antenna cable that is shipped with the antenna to the MP external antenna
connector.
Both connectors are labeled to indicate the radio type. The MP has standard SMA connectors for
attachment to the 802.11b/g antenna and to the 802.11a antenna.
2. Attach the other end of the antenna cable to the antenna.
Configuring the MP
To configure the channels, power settings, and other MP parameters, see the following:
Trapeze Mobility System Software Quick Start Guide
“Configuring MP Access Points” chapter in the Trapeze Mobility System Software Configuration
Guide
External Antenna Connectors
The Indoor MPs (except for the MP-432) havev connectors for attaching optional external antennas.
Table 1– 2 lists the external antenna models.
!
Caution
The external antenna must be installed at least 20 cm from the MP access point.
!
Caution
The external connectors on the MP are labeled: 11B/G and 11A. Each connector is a
standard SMA connector. Make sure you attach the antenna to the correct connector.
Note:
If the MP is installed in a Trapeze Networks outdoor MP enclosure, attach the antenna
cable to the lightning surge arrestor (if installed) or the enclosure’s SMA bulkhead
connector.
Note:
External antennas are not supported on the MP-432 or the MP-82.