User's Manual

Indoor Mobility Point™ Quick Start Guide
22
Trapeze Networks
2. Install the drywall anchor(s):
a. Hammer a drywall anchor into each hole, up to the beginning of the threads on the anchor.
b. Screw each anchor the rest of the way into its hole using a #2 Phillips-head screwdriver.
c. Remove the screw from each anchor and save the screw(s) for step 6 on page 22.
3. Unlock the universal mounting bracket from the MP access point by inserting the 1/8-inch or
3-mm screwdriver into the Unlock hole on the MP access point as shown in Figure 1–23.
Figure 1–23. Step 3—Unlocking the Bracket
4. Remove the bracket as shown in Figure 1–24.
Figure 1–24. Step 4—Removing the Bracket
5. As shown in Figure 1–25, feed the Cat 5 cable(s) through the port connector opening and align the
universal mounting bracket over the drywall anchors so that the two screw holes in the bracket
face the drywall anchors.
6. Insert the #6 sheet metal screws into the screw holes, and tighten them to secure the universal
mounting bracket to the wall or ceiling.
!
Caution
D
Use a small-pointed instrument or a paperclip to unlock the bracket. Do not use a
screwdriver because it may cause damage to the MP lock mechanism or electronic
components. Do not use excessive force when inserting a tool into the Unlock or Lock
hole.