User's Manual

Indoor Mobility Point™ Quick Start Guide
21
Trapeze Networks
Figure 1–22. Step 7—Locking the Bracket
9. To ensure that the MP access point is fully locked onto the bracket, gently pull down on the access
point and attempt to rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in step 8
on page 20.
10.If the MP requires an external antenna, install and connect the antenna. (See “Connecting an MP
to an External Antenna” .)
Solid Wall or Ceiling Installation
(For required mounting hardware and tools, see Table 1– 1 on page 8.)
1. Prepare holes in the wall or ceiling for the universal mounting bracket, using the following steps:
a. Place the paper mounting template over the location where you want to install the MP access
point.
b. Mark the screw hole location(s).
If you plan to route the Cat 5 cable externally along the wall or ceiling, mark the locations of
both the center screw hole and the screw hole by the port connector opening.
If you plan to route the Cat 5 cable through a hole in the wall or ceiling, mark the location of
the center screw hole only. You cannot use the screw hole by the port connector opening if you
cut a hole for the opening.
c. Remove the template.
Note:
The solid surface mounting option requires Cat 5 cable that does not have strain relief,
unless you plan to route the cable through a hole in the wall or ceiling. The other options
can use Cat 5 cable with or without strain relief.
Note:
Do not mark the four holes on the edges of the bracket. (These are the holes indicated by
the dashed lines in Figure 1–25.) The MP access point fits into these holes. They are not
screw holes.
Lock