User's Manual

Indoor Mobility Point™ Quick Start Guide
19
Trapeze Networks
Junction Box Installation
(For required mounting hardware and tools, see Table 1– 1 on page 8.)
1. Unlock the universal mounting bracket from the MP access point by inserting a small-pointed
instrument or a paperclip into the Unlock hole on the MP as shown in Figure 1–19.
Figure 1–19. Step 1—Unlocking the Bracket
2. Remove the bracket as shown in Figure 1–20.
Figure 1–20. Step 2—Removing the Bracket
3. Attach the universal mounting bracket to the junction box as shown in Figure 1–21:
a. Place the universal mounting bracket against the junction box so that the two screw holes face
the junction box and align over the screw holes in the box.
b. Insert the #6-32 x 1-inch machine screws in the universal mounting bracket’s screw holes, and
use a #2 Phillips-head screwdriver to tighten them.
!
Caution
D
Use a small-pointed instrument or a paperclip to unlock the bracket. Do not use a
screwdriver because it may cause damage to the MP lock mechanism or electronic
components. Do not use excessive force when inserting a tool into the Unlock or Lock
hole.