User's Manual

Indoor Mobility Point™ Quick Start Guide
14
Trapeze Networks
12.Lock the MP access point onto the bracket by inserting a small-pointed instrument or a paperclip
into the Lock hole on the MP as shown in Figure 1–10.
Figure 1–10. Step 11—Locking the Bracket
13.To ensure that the MP is fully locked onto the bracket, gently pull down on the access point and
attempt to rotate it from side to side.
14.If the access point comes off the bracket, relock the device onto the bracket.
15.If the MP requires an external antenna, install and connect the antenna. (See “Connecting an MP
to an External Antenna” .)
Suspended Ceiling Installation—Drop Ceiling Tiles
(For required mounting hardware and tools, see Table 1– 1 on page 8.)
1. Select an installation location that is centered over a T-bar in the ceiling.
2. Cut a hole as follows in the ceiling tile for the Cat 5 cable(s):
a. Place the mounting template over the area where you plan to install the MP access point.
b. Use the box cutter to cut along the line marking the opening for the port connectors.
c. Remove the mounting template and the material you cut from the ceiling panel.
3. Install the T-bar clamp that fits the T-bar:
a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.
b. Slide the two halves of the clamp toward each other until the tabs are inserted completely into
the holes and the clamp fits snugly on the T-bar.
Figure 1–11 shows an example for a 15/16-inch (23.9-mm ) T-bar. Figure 1–12 shows an example
for a 5/8-inch (15.9-mm) T-bar.
!
Caution
D
Use a small-pointed instrument or a paperclip to lock the MP. Do not use a screwdriver
because it may cause damage to the MP lock mechanism or electronic components. Do not
use excessive force when inserting a tool into the Unlock or Lock hole.
Lock