User's Manual

Indoor Mobility Point™ Quick Start Guide
13
Trapeze Networks
Figure 1–8. Step 7—Bottom View
8. Pull the Cat 5 cable(s) about 6 inches (about 15 cm) out of the hole in the ceiling tile and through
the port connector opening to create enough slack to insert the cable(s).
9. Insert the Cat 5 cable(s) into the connector(s):
For a single connection, use the connector for port 1.
For redundancy, insert one cable into each connector.
10.Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a person
pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
11.Lift the MP access point into place on the universal mounting bracket as shown in Figure 1–9.
Make sure the cable feeds properly into the ceiling as you lift the device, and does not become
trapped between the access point and the bracket.
Figure 1–9. Step 10—Placing the MP Access Point on the Bracket
T- b a r
Universal mounting bracketPort connector
opening