User's Manual

Indoor Mobility Point™ Quick Start Guide
12
Trapeze Networks
6. Remove the bracket as shown in Figure 1–6.
Figure 1–6. Step 6—Removing the Bracket
7. Install the universal mounting bracket as follows onto the T-bar or T-bar clamp:
a. As shown in Figure 1–7, place the universal mounting bracket against the T-bar or clamp so
that the two screw holes face downward and the two T-bar flanges face upward and are
adjacent to the T-bar edges.
Figure 1–7. Step 7—Top View
b. Properly align the bracket for mounting by placing the bracket so that its port connector
opening is to the left of the hole you cut for the cables.
c. Rotate the universal mounting bracket clockwise until the flanges snap into place on the T-bar
or clamp as shown in Figure 1–8.
T-bar
(Viewed from above ceiling tiles, looking down.)
Universal mounting
bracket
Port connector
opening