User's Manual
Table Of Contents
- Customer Service
- Introducing the Trapeze Networks Mobility System
- MP Overview
- Installing and Connecting an MP-372
- MP Troubleshooting
- MP Technical Specifications
- Translated Warning Conventions and Warnings
- Index
Verifying MP Health
Chapter 3
Trapeze Mobility Point Installation Guide
52
Verifying MP Health
After you install the MP access point and enable PoE on the Ethernet cable
connected to the MP, you can easily verify the MP’s status by observing the LEDs,
particularly the health LED. (See Figure 4 on page 12.)
The health or LINK LED indicates whether the MP access point is ready for
operation.
● If the LED is green and glowing steadily, the MP has been booted
successfully by the MX switch and is ready for operation.
● If the LED is not steadily glowing green, contact the system administrator for
the MX switch or, if you are the system administrator, see Appendix A, “MP
Troubleshooting,” on page 53.