User's Manual

Installing an MP-372
Chapter 3
Installing and Connecting an MP-372
43
7 Insert the Cat 5 cable(s) into the connector(s):
● For a single connection, use the connector for port 1.
● For redundancy, insert one cable into each connector.
8 Install the Kensington lock, if you plan to used one.
a Loop the Kensington lock’s cable around an object that cannot be moved
or damaged by a person pulling on the cable.
b Insert the key into the Kensington lock.
c Insert the Kensington lock into the security slot on the MP.
d Rotate the key right or left to secure the lock to the MP.
e Pull on the lock to verify that it is secured to the MP.
f Remove the key.
9 As shown in Figure 29, place the MP access point on the bracket, making sure
to remove any slack that occurs in the cable between the bracket and the MP
access point.
Figure 29. Step 8—Cable Placement
840-9502-0016
Universal mounting bracket
Cable