User's Manual

Installing an MP-372
Chapter 3
Trapeze Mobility Point Installation Guide
38
Figure 24. Step 3—Placing the Bracket on the Junction Box
4 Pull the Cat 5 cable(s) about 15 cm (about 6 inches) out of the junction box
and through the port connector opening to create enough slack to insert the
cable(s) into the port connectors.
5 Insert the Cat 5 cable(s) into the connector(s):
● For a single connection, use the connector for port 1.
● For redundancy, insert one cable into each connector.
6 Install the Kensington lock, if you plan to used one.
a Loop the Kensington lock’s cable around an object that cannot be moved
or damaged by a person pulling on the cable.
b Insert the key into the Kensington lock.
c Insert the Kensington lock into the security slot on the MP.
d Rotate the key right or left to secure the lock to the MP.
e Pull on the lock to verify that it is secured to the MP.
f Remove the key.
840-9502-0017
Junction box
Port connector
opening