User's Manual
Table Of Contents
- Customer Service
- Introducing the Trapeze Networks Mobility System
- MP Overview
- Installing and Connecting an MP-372
- MP Troubleshooting
- MP Technical Specifications
- Translated Warning Conventions and Warnings
- Index
Installing an MP-372
Chapter 3
Installing and Connecting an MP-372
35
Figure 21. Step 10—Locking the Bracket
12 To ensure that the MP access point is fully locked onto the bracket, gently pull
down on the access point and attempt to rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as
described in step 11 on page 34.
13 If the MP requires an external antenna, install and connect the antenna. (See
“Connecting an MP to an External Antenna” on page 49.)
14 If the other ends of the Cat 5 cable(s) are not already connected and the link
activated, go to “Connecting an MP to an MX Switch” on page 50. Otherwise,
go to “Verifying MP Health” on page 52.
840-9502-0006
L
o
ck
T-bar