User's Manual

Installing an MP-372
Chapter 3
Trapeze Mobility Point Installation Guide
34
9 Install the Kensington lock, if you plan to used one.
a Loop the Kensington lock’s cable around an object that cannot be moved
or damaged by a person pulling on the cable.
b Insert the key into the Kensington lock.
c Insert the Kensington lock into the security slot on the MP.
d Rotate the key right or left to secure the lock to the MP.
e Pull on the lock to verify that it is secured to the MP.
f Remove the key.
10 Lift the MP access point into place on the universal mounting bracket as
shown in Figure 20.
Make sure the cable feeds properly into the ceiling as you lift the device, and
does not become trapped between the access point and the bracket.
Figure 20. Step 9—Placing the MP Access Point on the Bracket
11 Lock the MP access point onto the bracket by inserting the 3-mm or 1/8-inch
screwdriver into the Lock hole on the access point as shown in Figure 21.
Caution! To prevent possible damage to the MP access point, make
sure the device is fully locked onto the bracket before letting go of it.
840-9502-0002