User's Manual

Installing an MP-372
Chapter 3
Trapeze Mobility Point Installation Guide
32
5 Remove the bracket as shown in Figure 17.
Figure 17. Step 5—Removing the Bracket
6 Install the universal mounting bracket as follows onto the T-bar clamp:
a As shown in Figure 18, place the universal mounting bracket against the
T-bar clamp so that the two screw holes face downward and the two T-bar
flanges face upward and are adjacent to the T-bar edges.
b Properly align the bracket for mounting by placing the bracket so that its
port connector opening is to the left of the hole you cut for the cables.
c Rotate the universal mounting bracket clockwise until the flanges snap
into place on the T-bar clamp as shown in Figure 19.
840-9502-0008