User Manual Part 2

Trapeze Regulatory Information
3
Regulatory Compliance Information
Regulatory Compliance Information
Trapeze Networks products cause no electromagnetic interference to other devices if installed and operated
properly and without modification.
Modification Prohibition
The manufacturer, Trapeze Networks, is not responsible for any interference caused by unauthorized
modification of the devices included with this product, or the substitution or attachment of connecting
cables or equipment other than supplied by Trapeze Networks.
The correction of interference caused by such unauthorized modification, substitution, or attachment is
your responsibility.
Trapeze Networks and its authorized resellers or distributors are not liable for any damage or violation of
government regulations that might arise from failure to comply with these guidelines.
Wiring Notice
Federal Communications Commission Notice (United States)
This device uses, generates, and radiates radio frequency energy. The radio frequency energy produced by
this device is well below the maximum exposure allowed by the Federal Communications Commission
(FCC).
Operation is subject to the following conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B or Class A (as marked)
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential environment.
Caution! The Part 15 radio device in the access point operates on a noninterference basis
with other devices operating at the same frequency. Any modification to this device not
expressly approved by Trapeze Networks can void your authority to operate the device.
Note. Other than the power cord, the wiring interconnecting these units is designed to be
used intra-building only.