User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Trapeze Mobility Point Installation Guide
Version 2.1
44
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
Figure 31. Step 9—Locking the Bracket
10 To ensure that the MP access point is fully locked onto the bracket, gently pull
on the access point and attempt to rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as
described in step 9 on page 43.
11 If the MP requires an external antenna, install and connect the antenna. (See
“Connecting an MP to an External Antenna” on page 47.)
12 If the other ends of the Cat 5 cable(s) are not already connected to an MX
switch and the link activated, go to “Connecting an MP to an MX Switch” on
page 48. Otherwise, go to “Verifying MP Health” on page 51.
Tabletop Installation
(For required mounting hardware and tools, see Table 5 on page 22.)
1 Reverse the universal mounting bracket:
840-9502-0062
Lock