User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Installing and Connecting an MP
41
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
Figure 28. Step 4—Removing the Bracket
5 As shown in Figure 29, feed the Cat 5 cable(s) through the port connector
opening and align the universal mounting bracket over the drywall anchors so
that the two screw holes in the bracket face the drywall anchors.
6 Insert the #6 sheet metal screws into the screw holes, and tighten them to
secure the universal mounting bracket to the wall or ceiling.
(If you routed the Cat 5 cable through a hole in the wall or ceiling, insert the
screw into the center screw hole only.)
Note. Do not insert screws in the four holes on the edges of the
bracket. (These are the holes indicated by the dashed lines in
Figure 29.) The MP access point fits into these holes. They are not
screw holes.
840-9502-0008