User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Trapeze Mobility Point Installation Guide
Version 2.1
38
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
Make sure the cable feeds properly into the junction box as you lift the device,
and does not become trapped between the access point and the bracket.
7 Lock the MP access point onto the bracket by inserting the 3-mm or 1/8-inch
screwdriver into the Lock hole on the access point as shown in Figure 26.
Figure 26. Step 7—Locking the Bracket
8 To ensure that the MP access point is fully locked onto the bracket, gently pull
down on the access point and attempt to rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as
described in step 7 on page 38.
9 If the MP requires an external antenna, install and connect the antenna. (See
“Connecting an MP to an External Antenna” on page 47.)
10 If the other ends of the Cat 5 cable(s) are not already connected to an MX
switch and the link activated, go to “Connecting an MP to an MX Switch” on
page 48. Otherwise, go to “Verifying MP Health” on page 51.
Caution! To prevent possible damage to the MP access point, make
sure the device is fully locked onto the bracket before letting go of it.
840-9502-0062
Lock