User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Installing and Connecting an MP
37
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
3 Attach the universal mounting bracket to the junction box as shown in
Figure 25:
a Place the universal mounting bracket against the junction box so that the
two screw holes face the junction box and align over the screw holes in
the box.
b Insert the #6-32 x 1-inch machine screws in the universal mounting
bracket’s screw holes, and use a #2 Phillips-head screwdriver to tighten
them.
Figure 25. Step 3—Placing the Bracket on the Junction Box
4 Pull the Cat 5 cable(s) about 15 cm (about 6 inches) out of the junction box
and through the port connector opening to create enough slack to insert the
cable(s) into the port connectors.
5 Insert the Cat 5 cable(s) into the connector(s):
● For a single connection, use the connector for port 1.
● For a dual-homed connection, insert one cable into each connector.
6 Lift the MP access point into place on the universal mounting bracket.
840-9502-0017
Junction box
Port connector
opening