User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Installing and Connecting an MP
27
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
Figure 11. Step 7—Top View
b Properly align the bracket for mounting by placing the bracket so that its
port connector opening is to the left of the hole you cut for the cables.
c Rotate the universal mounting bracket clockwise until the flanges snap
into place on the T-bar or clamp as shown in Figure 12.
Figure 12. Step 7—Bottom View
8 Pull the Cat 5 cable(s) about 15 cm (about 6 inches) out of the hole in the
ceiling tile and through the port connector opening to create enough slack to
insert the cable(s).
9 Insert the Cat 5 cable(s) into the connector(s):
T-bar
(Viewed from above ceiling tiles, looking down.)
840-9502-0005
Universal mounting
bracket
Port connector
opening
T-bar
Universal mounting bracket
840-9502-0004
Port connector
opening