User's Manual

Installing an MP—Model MP-241, MP-252, and MP-262
Chapter 3
Trapeze Mobility Point Installation Guide
Version 2.1
24
Confidential—Beta Draft—Confidential—Beta Draft—12 May 04
Figure 7. Universal Mounting Bracket
Suspended Ceiling Installation—Flush Ceiling Tiles
(For required mounting hardware and tools, see Table 5 on page 22.)
1 Select an installation location that is centered over a T-bar in the ceiling.
2 Cut a hole as follows in the ceiling tile for the Cat 5 cable(s):
a Place the mounting template over the area where you plan to install the
MP access point.
b Use the box cutter to cut along the line marking the opening for the port
connectors.
c Remove the mounting template and the material you cut from the ceiling
panel.
3 Determine whether to install a T-bar clamp onto the ceiling T-bar:
● If the T-bar width is 14.2 mm (9/16 inches), you need to install the
14.2-mm (9/16-inch) T-bar clamp. Go to step 4.
● If the T-bar width is 23.9 mm (15/16 inches), the universal mounting
bracket fits directly onto the T-bar. Go to step 5.
4 Install the 14.2-mm (9/16-inch) T-bar clamp onto the ceiling T-bar as shown
in Figure 8.
840-9502-0018
Port connector
opening
T-bar flanges
Screw holes