User's Manual
Table Of Contents
- Trapeze Regulatory Information
- Hardware Safety Symbols
- Safety and Advisory Notice Conventions
- Radio Channels and Maximum Transmit Power
- Regulatory Compliance Information
- Modification Prohibition
- Wiring Notice
- Federal Communications Commission Notice (United States)
- Canadian Department of Communications Industry Canada Notice (Canada)
- Radio Frequency Compliance Information (European Union)
- Voluntary Control Council for Interference by Information Technology Equipment Notice (Japan)
- Regulatory Compliance Notice (Korea)
- Lithium Battery Caution
- Declarations of Conformity
- Translations of Warnings and Warning Conventions
Trapeze Regulatory Information
9
Regulatory Compliance Information
Federal Communications Commission Notice (United States)
This device uses, generates, and radiates radio frequency energy. The radio frequency energy produced by
this device is well below the maximum exposure allowed by the Federal Communications Commission
(FCC).
Operation is subject to the following conditions:
● This device may not cause harmful interference.
● This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B or Class A (as marked)
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential environment.
This accepted equipment is designed and tested to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed in accordance with the instruction
manual, may cause harmful interference.
There is no guarantee that interference will not occur. If this equipment does cause interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to correct the interference by one of the following measures:
● Reorient or relocate the device to reorient or relocate the receiving antenna.
● Increase separation between the equipment and receiver.
Canadian Department of Communications Industry Canada Notice
(Canada)
This digital apparatus meets the requirements of Canadian Interference-Causing Equipment Regulation
RSS-210.
Cet appareil respecte les exigences du Reglement sur le material broilleur du Canada.
This device complies with the limits of Industry Canada (IC). Operation is subject to the following
conditions:
● This device may not cause harmful interference.
● This device must accept any interference received, including interference that may cause undesired
operation.
The device is certified to the requirements of IC RSS-139-1. The use of this device in a system operating
either partially or completely outdoors may require the user to obtain a license for the system. For more
information, contact your local Industry Canada office.