Instructions / Assembly

During the installation of springs, wear

gloves and protective eye wear (not provided).

Frame

3. Lay the Bed (6) on the ground inside of the

assembled frame. Make sure that the two warn-

ing decals (not shown) are on top of the Bed.

Note: There are V-rings around the edge of the

Bed (6) and holes around the top and bottom

of the frame.

During this step, you will attach the Bed to the frame

using the included Springs for holes on frame (see the

inset drawing). Hook a spring to the Bed (6) and using

the spring pulling tool (11), pull the spring from the Bed

to the hole slot in the trampoline frame with even spring

tension. Attach a second spring (5) directly across the bed

from the rst spring (5). Attach two more springs (5) halfway

between the rst two springs, so four spring (5) are attached

as shown. Attach four more springs (5) (not shown) halfway

between the rst four springs (5). Continue attaching springs

(5) halfway between the previously attached springs (5),

until all the springs (5) are attached.

3.5” Spring (5):

Hook the V-ring

Hook the top tube

V-ring

Spring holes on top of toprail

4. Lay the Frame Pad (7) on the frame. Adjust the position of

the Frame Pad so the notches are aligned with the

T-connector+welded tube as shown. Be sure the adjustable

handle frame openings are t to the T-connector+welded

tube position.

Do not use the trampoline without the Frame

Pad (7), which is designed to reduce the likeli-

hood of injury to the user from coming in con-

tact with the trampoline frame. If you do not

have a Frame Pad, contact your dealer to

obtain one. Properly install the Frame Pad

before using the trampoline.

Notch

T-connector+welded

and straight(4)